Comtech EF Data CDM-570A - Manual (Page 318)

CDM-570A/570AL Satellite Modem with Optional Packet Processor MN-CDM570A
Optional Packet Processor - Serial/Telnet CLI Operation Revision 2
9–22
9.3.3.1.2 Ethernet Interface (Router Mode)
(TOP) Dedicated Management Port = DISABLED
(BOTTOM) Dedicated Management Port = ENABLED
Figure 9-11. Ethernet Interface in Router Mode
You must set the Traffic Port Speed/Mode to match the Ethernet port settings of the
connected device port to avoid experiencing significant performance degradation.
For example, if the connected device port is set for Auto Negotiate, then you must
also set the Packet Processor to Auto Negotiate. Comtech EF Data recommends that
you use Auto Negotiate mode, unless the connected device port does not support
Auto Negotiate. In such cases, both Ethernet ports must be set to the same Manual
settings (i.e., 100 Mbps Full Duplex).
Selection Hot Key Description
Mgmt MAC Address [RO] This is the hardware destination MAC Address that is used when an
Ethernet packet is destined for the Packet Processor M&C Ethernet
Interface. This address is unique and has been assigned permanently
at the factory.