Comtech EF Data CDM-570A - Manual (Page 162)

CDM-570A/570AL Satellite Modem with Optional Packet Processor MN-CDM570A
Front Panel Operation Revision 2
6–58
Use the ◄ ► arrow keys to Disable or Enable the warm-up delay feature. Press ENTER.
If you select Disable, the modem powers up, and goes into normal operational service without
delay.
If you select Enable, one of the following screens displays when the modem powers up:
CDM/R-570ALunit: CDM-570A unit:
The bottom line counts down, in seconds, the time remaining for the warm-up period. During
this period, the Tx Carrier is deliberately muted. At the end of the warm-up period, the bottom
line reverts to the ‘normal’ opening screen display (i.e., it displays the Firmware version), and
the modem ENTERs into its normal operational state.
Bypass (override) the warm-up period at any time by pressing the CLEAR key.
6.3.7.4 UTIL: ID (Circuit ID)
Edit Circuit ID:(◄ ►,▲ ▼)
24 CHARACTER TST MESSAGE
A 24-character Circuit ID string may be composed on the bottom line only. To compose the
Circuit ID string, first use the ◄ ► arrow keys to select a character to edit. Then, use the
▲▼arrow keys to edit that character. Press ENTER.
The following characters are available (a maximum length of 24 characters of allowed):
[Space] ( ) * + - . / 0 through 9 and A through Z.
6.3.7.4.1 UTIL: 1:1 (Manual 1:1 Switchover)
Press ENT to force modem
to Standby (1:1 ONLY)
If this modem is the online unit in a 1:1 redundant configuration, press ENTER to force the unit
into Standby mode. Otherwise, press CLEAR to exit this menu and return to the previous menu
without causing the switchover.
Comtech CDM-570A Modem
Ref Warming-up: 045
Comtech CDM/R-570ALModem
Ref Warming-up: 045