2 (kst select: ► kst config:) receiver – Comtech EF Data CDM-570A User Manual
Page 394
CDM-570A/570AL Satellite Modem with Optional Packet Processor
MN-CDM570A
CDM-570A/570AL ODU (Transceiver, BUC, LNB) Operation
Revision 2
10–20
(KST CONFIG: ► KST TX:) HPA ► Fault-Logic
HPA Fault Logic: Summary
No-Summary (◄ ►,ENT)
To control whether or not HPA fault will activate the SUMMARY FAULT RELAY, use the
◄ ► arrow keys to select Summary or No-Summary. Press ENTER when done.
10.2.1.2.2.1.1.2 (KST SELECT: ► KST CONFIG:) Receiver
KST RX: Frequency Atten
LNA (◄ ►,ENT)
KST RX: Frequency Atten
LNB (◄ ►,ENT)
Use the
◄ ► arrow keys to select Frequency, Atten, or LNA/LNB, and then press ENTER.
(KST CONFIG: ► KST RX:) Frequency
ODU Rx Frequency:
10950.0 MHz (◄ ►,▲ ▼,ENT)
To edit the receive frequency, first use the
◄ ► arrow keys to select a digit, and then use
the
▲▼arrow keys to change the value of that digit. Press ENTER when done.
(KST CONFIG: ► KST RX:) Atten (Attenuation)
ODU Rx Attenuation:
15 dB (◄ ►,▲ ▼,ENT)
To edit the receive attenuation, first use the
◄ ► arrow keys to select a digit, and then use
the
▲▼arrow keys to change the value of that digit. Press ENTER when done.
(KST CONFIG: ► KST RX:) LNA
LNA: State Fault-Logic
Calibrate (◄ ►,ENT)
Use the
◄ ► arrow keys to select State, Fault-Logic, or Calibrate, and then press ENTER.
(KST CONFIG: ► KST RX:) LNA ► State
ODU LNA State:
On Off (◄ ►,ENT)
To control whether or not the ODU provides LNA POWER via the Receive RF Cable, use
the
◄ ► arrow keys to select ON or OFF. Press ENTER when done.
(Displayed when ODU is a KST-2000A unit)
(Displayed when ODU is a KST-2000B unit)
(Displayed when ODU is a KST-2000A unit)