Comtech EF Data CDM-570A - Manual (Page 211)

CDM-570A/570AL Satellite Modem with Optional Packet Processor MN-CDM570A
Ethernet-based Remote Product Management Revision 2
7–43
The information that follows is applicable only when QoS Mode = Rule –
Max/Priority Mode
QoS Max/Priority Rules Table
This section displays all existing QoS Max/Priority Rules Table entries. From left to right:
Column Description
Index This is the internal table index that is automatically assigned and cannot be edited.
Protocol Specifies the protocol for the specific rule.
Src IP Addr Identifies the Source IP Address in the form XXX.XXX.XXX.XXX.
Src IP Mask Identifies the Source IP Mask in the form YY.
Src IP Addr Identifies the Destination IP Address in the form XXX.XXX.XXX.XXX.
Dest IP Mask Identifies the Destination IP Mask in the form YY.
Min Src Port Specifies the Minimum Source Port.
Max Src Port Specifies the Maximum Source Port.
Min Dst Port Specifies the Minimum Destination Port.
Max Dst Port Specifies the Maximum Destination Port.
Max BW (Kbps) Specifies the Maximum Bandwidth value in kilobits per second.
Priority Specifies the priority established for the specific rule (1-8).
WRED Specifies the WRED (Weighted Random Early Detection) setting for the specific rule as
Disable or Enable.
Filtering Specifies the flow filter setting for the specific rule as Disable or Enable.
Add New QoS Rule
This section allows you to directly add a new Max/Priority QoS Rule.
• Protocol / Priority / WRED / Filtering – Use the drop-down list to select the desired
operation.
• Src IP Mask / Dst IP Addr and Mask / Min and Max Src Port / Min and Max Dst Port / Max
BW (Kbps) – Entire the desired value parameter as needed.
Click [Add Rule] to save. When you add a new rule to the QoS Max/Priority Rules Table, the
modem automatically assigns an internal table index number to the table.