Comtech EF Data CDM-570A - Manual (Page 149)

CDM-570A/570AL Satellite Modem with Optional Packet Processor MN-CDM570A
Front Panel Operation Revision 2
6–45
• When you do not enable AUPC, both maximum and average TPLI shows ‘Off'.
Examples: 08.0,13.5,2.5,1.8 means:
Minimum E
b
/N
0
observed in the measurement interval = 8.0 dB
Average E
b
/N
0
observed in the measurement interval = 13.5 dB
Maximum TPLI observed in the measurement interval = 2.5 dB
Average TPLI observed in the measurement interval = 1.8 dB
Loss,04.5,Off,Off means:
There was a loss of demod lock during the measurement interval
Average E
b
/N
0
observed in the measurement interval = 4.5 dB
Maximum TPLI observed in the measurement interval = AUPC disabled
Average TPLI observed in the measurement interval = AUPC disabled
6.3.3.5.2 (MONITOR: Link Statistics) Clear-All
Clear all Stored Stats?
No Yes (▲ ▼, ENTER)
Use the ▲▼arrow keys to choose No or Yes. Press ENTER. When you select Yes, the modem
clears the Link Statistics Log and returns you to the previous menu.
6.3.3.5.3 (MONITOR: Link Statistics) Config (Configure)
Stats Logging Interval:
Disabled (▲ ▼,ENTER)
Valid logging interval settings (i.e., the time span, in minutes, over which the link statistics are
measured) are Disabled, 10, 20, 30, 40, 50, 60, 70, 80, or 90.
To select a logging interval the ▲▼arrow keys to select your desired interval setting. Press
ENTER. Once set, the display reflects the selected interval:
Stats Logging Interval:
30 minutes (▲ ▼,ENTER)