Comtech EF Data CDM-570A - Manual (Page 192)

CDM-570A/570AL Satellite Modem with Optional Packet Processor MN-CDM570A
Ethernet-based Remote Product Management Revision 2
7–24
7.4.3.2.7 Admin | PaP Save
This page is available only when you install the optional Packet Processor.
Figure 7-10. Status | PaP Save Page
You must click [Save PaP Parameters] on this page, in addition to changes made to the following
CDM-570A HTTP Interface pages:
CDM-570A HTTP Interface Page See Chapter Section…
Admin | Pap Features 7.4.3.2.4
Admin | Firmware | Packet Processor 7.4.3.2.5.2
Configuration | LAN (only when the optional Packet Processor
is INSTALLED)
7.4.3.3.2
Configuration | ARP 7.4.3.3.3
Any nested Configuration | Routing page 7.4.3.3.4
Configuration | Managed Switch 7.4.3.3.5
Any nested Configuration | WAN page 7.4.3.3.6
Redundancy (only when the optional Packet Processor is
INSTALLED)
7.4.3.6
Note that the modem reboots automatically if any changes are submitted to the ‘Admin |
Working Mode’ page (see Sect. 7.4.3.2.3).