Installing the sensors – Dr. Livingstone, I Presume WELDWISE 2400 User Manual
Page 95
0434-INS-400 Rev. C
7-1
Red: Current sensor
Green: Voltage sensor
Yellow: Force sensor
Blue: Displacement sensor
Figure 7-1 Color-coding on the Monitor-Sensor cable
Installing the Sensors
The Monitor-Sensor cable included with a WeldWise™ 2400 routes input from four possible external
signal sources (Current, Voltage, Force, and Displacement sensors) to the weld monitor. Each sensor
must be attached to the appropriate cable lead as indicated by the color-coding. It is not necessary to
have a sensor attached to every lead, however a Livingston current toroid must always be used.
Note:
Any sensor lead not in use should have its connector protected to prevent contamination of
internal pins.
The Monitor-Sensor cable attaches to the weld monitor as
shown below:
Figure 7-2 Attaching the Monitor-Sensor
cable to a 2400