Dr. Livingstone, I Presume WELDWISE 2400 - Manual (Page 85)

0433-INS-400 Rev. E
6-39
Input Monitor
The Input Monitor display allows you to see the
raw data readings from the sensor input channels
(A/D values) as well as the calibrated readings for
Voltage, Force, and Displacement are also shown
(Value). Calculated Current values are not
displayed. The values in this screen change as the
monitor continuously updates each channel.
If the sensor has not been properly calibrated, the
incoming calibrated readings shown in the Value
column will not be correct.
Use the Input Monitor after calibrating a sensor to
check the validity of your calibration adjustment.
A/D values of (+32767) and (-32768) indicate saturation or overflow on that channel. If all of the A/D
values appear frozen, you may have a problem with your monitor. Refer to Chapter 10,
Troubleshooting Guide for more information.
• External Master Select
This value indicates the binary select (Master Select number) that the weld monitor is receiving
from the External inputs at the rear of the monitor.
• Current Master Select
This value indicates the master that is in use, whether from an external or internal selection. If the
Binary Select (Master select) value does not correspond to an existing master, then the Current
Master Select will be 0 (No Master).
• Zero Displacement
This button is used to re-establish the range in which the displacement readings are being taken.
Refer to Chapter 11, Displacement Channel Overview for additional information.
Figure 6-52 Input Monitor