Dr. Livingstone, I Presume WELDWISE 2400 - Manual (Page 70)

0433-INS-400 Rev. E
6-24
Edit Master Screen
The Edit Master screen is shown below in figure 6-39. The graph line represents the data for the
displayed parameter and weld number. The shaded area represents the average of all the welds
included in the master set. If there was more than one weld used to create the master, the screen will
display the first weld in the set.
• Parameter Pickbox
The parameter select box corresponds to the y-axis (vertical). This allows you to view data for any
of the parameters while editing a master.
• Weld Number Select / Display
The weld number select allows you to select any of the welds that were used to create the current
master.
• Add/Delete Button
Use this button to add/delete welds to/from
the master set. If a weld is accidentally deleted
from the master set, it can be re-added using
the Add button. New welds cannot be added
to an existing master set. Refer to Chapter 10,
FAQ for further information.
• Edit Pod ID / Edit Bin Sel buttons
Use these buttons to edit the Pod ID and
binary select associated with this master.
Note: The master name (by default, a date/time stamp) can be changed by using the Alt-R key
combination via an external keyboard attached to the monitor. Use the ENTER key to save the new
name and ESCAPE to return to the Edit Master screen. See page Attaching Peripherals in Chapter
11, Appendices for more information about connecting an external keyboard to your monitor.
Master ID
Parameter pickbox
Add/Delete button
Weld number
select/display
Figure 6-39 Edit Master
Figure 6-40 Rename Master screen
Edit Pod ID
Edit Bin Sel
buttons