Dr. Livingstone, I Presume WELDWISE 2400 - Manual (Page 77)

0433-INS-400 Rev. E
6-31
General Setup
The General Setup is used to change the general
configuration of a WeldWise™ 2400. The
Current ID at the bottom of the screen is the ID
to which the configuration settings apply.
Separate configuration settings for each ID are
maintained in the database. After the settings in
this menu are adjusted for a particular weld
process application, they should be archived using
an Export Setup command. For more
information, refer to, Database Export options in
Chapter 6.
NOTE: Pod Servers and the WeldWise™ 2400
use the same User Interface software and by
default contain the same General Setup
parameters in the livco.mdb database. Not all of
these parameters are used by BOTH the Pod
Server and 2400 systems. Please refer to General
Setup Parameter descriptions (below) in order to
determine which parameters apply to your system.
• Current ID
This refers to the ID whose general
configuration settings are shown and edited in
this menu. Current ID is typically set to 60
• Update Configuration button
This button is used to Update the settings to the
weld monitor. The settings will not take effect until updated!
Figure 6-50 General Setup Menu