Dr. Livingstone, I Presume WELDWISE 2400 - Manual (Page 153)

0614-INS-400 Rev. D
11-7
What If?
What if someone made changes to some settings and then forgot the known-good settings, or changed
sensor calibration and then realized that they had made a mistake and wanted to put these things back
to the way they were prior to the mishap?
Use either the “Import All” or the “Import Setup” utility to recover the known good
settings.
OR
If a floppy was created with the “Export Setup from Floppy” then insert the floppy
and use the “Import Setup from Floppy” option.
What if someone accidentally deleted a master or master tolerance limits?
Use either the “Import All” or the “Import Masters” utility to recover the known good
masters.
OR
If a floppy was created with the “Export Masters from Floppy” then insert the floppy
and use the “Import Masters from Floppy” option.
What if at some point a sudden lost of power to the WeldWise 2400 causes a “hard” shutdown of the
unit, resulting in corrupt databases?
Use the “Import All” option for a full recovery and consider installing a UPS.
What if something happened that physically damaged the WeldWise 2400 to the point that it needed to
be replaced?
1) Find your spare WeldWise 2400.
2) Find your backup copy of livco.mdb and welddata.mdb that you luckily stored on
another computer.
3) Copy the backup files (livco.mdb and welddata.mdb), into the ‘\\livcosetup’ folder
located on the spare WeldWise 2400.
4) Install the spare WeldWise 2400 and attach the sensor cable.
5) Resume production.