Dr. Livingstone, I Presume WELDWISE 2400 - Manual (Page 129)

PROBLEM POSSIBLE CAUSE OR
SYMPTOM
POSSIBLE FIX
Sensor cable disconnected. Check to see if the sensor cable is properly connected to the
weld monitor.
Toroid disconnected or damaged. Inspect the toroid for poor connections and/or physical damage
or abrasion. Reconnect, replace and/or relocate toroid if
necessary.
A-D Threshold setting is too
high/incorrect. In the General Setup Menu, decrease setting until a weld is
detected.
WELD COUNT DOES
NOT INCREASE
Hardware/Software failure Call Livingston Service.
10-13
0455
-INS-4
00
R
ev
. C