Dr. Livingstone, I Presume WELDWISE 2400 User Manual

Page 65

0433-INS-400

Rev.

6-19

• Export Masters To Floppy
This option is the same as the Export Masters
command above, except that the archive
database is compressed and stored to a floppy
disk. This command will overwrite any masters
written by a previous Export Masters To
Floppy command. Only one masters archive
can be stored on a floppy disk.

Note:

A floppy disk can typically hold 1.4MB. If

the data you are trying to export exceeds that
size, it should be transferred via a networked
computer. Call Livingston Service for
additional information.

WARNING: Welds cannot be monitored while

the Export Masters to Floppy option is in
use. Any remote user interface windows
must also be closed. If the Cancel button is
used, the weld monitor must be shut down and
restarted. DO NOT shutdown the weld
monitor during this operation.

• Export Setup
This option saves the current general setup and
sensor calibration information to an archive
database. The setup archive database file name
is setup.mdb. This command will overwrite
the existing setup and calibration data.

WARNING: Welds cannot be monitored while the Export Masters to Floppy option is in use.

Any remote user interface windows must also be closed. If the Cancel button is used, the weld
monitor software must be shut down and restarted. DO NOT shutdown the weld monitor during
this operation.

• Export Setup To Floppy
This option is the same as the Export Setup command above, except that the archive database is
compressed and stored to a floppy disk. This command will over-write any setup information
written by a previous Export Setup To Floppy command. Only one setup archive can be stored
on a floppy disk.

WARNING: Welds cannot be monitored while the Import Setup From Floppy option is in use.

Figure 6-31 Export Setup

Figure 6-32 Export Setup to Floppy