Dell PowerEdge M600 - Manual (Page 564)

564 ARP Commands
www
.dell.com | support.dell.com
may also respond if the target IP address is reachable. The device only responds if all next hops in
its route to the destination are through interfaces other than the interface that received the ARP
request. Use the no form of the command to disable proxy ARP on a router interface.
Syntax
ip proxy-arp
no ip proxy-arp
Default Configuration
Enabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example enables proxy arp for VLAN 15.
(config)#interface vlan 15
console(config-if-vlan15)#ip proxy-arp
show arp
Use the show arp command in Privileged EXEC mode to display the Address Resolution Protocol
(ARP) cache. The displayed results are not the total ARP entries. To view the total ARP entries, the
operator should view the show ARP results in conjunction with the show ARP switch results.
Syntax
show arp [brief] [switch]
• brief—Display ARP parameters and cache.
• switch—Display ARP cache for the switch.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.