Dell PowerEdge M600 - Manual (Page 308)

288 ACL Commands
www
.dell.com | support.dell.com
Example
The following example configures a MAC ACL to deny traffic from MAC address
0806.c200.0000.
console(config)#mac access-list extended DELL123
console(config-mac-access-list)#deny 0806.c200.0000 ffff.ffff.ffff
any
ip access-group
no ip access-group
Use the ip access-group or no ip access-group command to apply/disable an IP based egress ACL
on an Ethernet interface or a group of interfaces. An IP based ACL should have been created by the
access-list … command with the same name specified in this command.
Syntax
ip access-group name direction
• name—Access list name. (Range: Valid IP access-list name up to 31 characters in length)
• direction—Direction of the ACL. (Range: In or out)
Default Configuration
This command has no default configuration.
Command Mode
Global and Interface Configuration
User Guidelines
Global mode command configures the ACL on all the interfaces, whereas the interface mode
command does so for the interface.
Examples
console(config)#ip access-group aclname in
console(config)#no ip access-group aclname in
console(config)#ip access-group aclname1 out
console(config-if-1/g1)#ip access-group aclname out
console(config-if-1/g1)#no ip access-group aclname out