Dell PowerEdge M600 - Manual (Page 765)

PIM-SM Commands 773
console(config-if-vlan15)#ip pimsm mode
ip pimsm query-interval
Use the ip pimsm query-interval command in Interface Configuration mode to configure the
transmission frequency of hello messages in seconds between PIM enabled neighbors.
Syntax
ip pimsm query-interval seconds
no ip pimsm query-interval
• seconds—Transmission frequency. (Range: 10-3600 seconds)
Default Configuration
30 seconds is the default value.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example enables the administrative mode of PIM-SM multicast routing for
VLAN 15.
console(config)#interface vlan 15
console(config-if-vlan15)#ip pimsm query-interval 50
ip pimsm register-rate-limit
Use the ip pimsm register-rate-limit command in Global Configuration mode to configure the
Register Threshold rate for the RP (Rendezvous Point) router to switch to the shortest path. The
rate is specified in Kilobits per second.
Syntax
ip pimsm register-rate-limit rate
• rate—0-2000 kilobits per second
Default Configuration
This command has no default configuration.