Dell PowerEdge M600 - Manual (Page 183)

Ethernet Configuration Commands 151
Example
The following example configures the duplex operation of Ethernet port 5 to force full duplex
operation.
console(config)# interface ethernet 1/g5
console(config-if-1/g5)# duplex full
flowcontrol
Use the flowcontrol command in Global Configuration mode to configure the flow control. To
disable flow control, use the no form of this command.
Syntax
flowcontrol
no flowcontrol
Default Configuration
Flow Control is disabled.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
In the following example, flow control is enabled.
console(config)# flowcontrol
interface ethernet
Use the interface ethernet command in Global Configuration mode to enter the interface
configuration mode to configure an Ethernet type interface.
Syntax
interface ethernet interface
• interface—Valid Ethernet port. The full syntax is unit/port.
Default Configuration
This command has no default configuration.