Dell PowerEdge M600 - Manual (Page 449)

Port Channel Commands 441
Port Channel Commands
channel-group
Use the channel-group command in Interface Configuration mode to configure a port-to-port
channel. To remove the channel-group configuration from the interface, use the no form of this
command.
Syntax
channel-group port-channel-number mode {on|auto}
no channel-group
• port-channel_number—Specifies the number of the valid port-channel for the current
port to join.
• on—Forces the port to join a channel without LACP.
• auto—Forces the port to join a channel with LACP.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example shows how port 1/g5 is configured to port-channel number 1 without
LACP.
console(config)# interface ethernet 1/g5
console(config-if-1/g5)# channel-group 1 mode on