Dell PowerEdge M600 - Manual (Page 764)

772 PIM-SM Commands
www
.dell.com | support.dell.com
Syntax
ip pimsm message-interval interval
no ip pimsm message-interval
• interval—Join/prune interval. (Range: 10-3600 seconds)
Default Configuration
60 is the default value for the join/prune interval.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures a global join/prune interval for PIM-SM router of 100.
console(config)#ip pimsm message-interval 100
ip pimsm mode
Use the ip pimsm mode command in Interface Configuration mode to set to enabled the
administrative mode of PIM-SM multicast routing on a routing interface.
Syntax
ip pimsm mode
no ip pimsm mode
Default Configuration
Disabled is the default state.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example enables the administrative mode of PIM-SM multicast routing for
VLAN 15.
console(config)#interface vlan 15