Dell PowerEdge M600 - Manual (Page 274)

252 System Management Commands
www
.dell.com | support.dell.com
Example
The following example displays how to move the Management Switch functionality from
switch "1" to switch "8."
console(config)#stack
console(config)#movemanagement 1 2
no cut-through mode
Use the no cut-through mode command to disable the cut-through mode on the switch. The
command takes effect on all ports on next reload of the switch.
Syntax
no cut-through mode
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration
User Guidelines
No specific guidelines.
Example
Console(config)#no cut-through mode
The mode (disable) is effective from the next reload of
Switch/Stack.
no standby
Use the no standby command to unconfigure the standby in the stack. In this case, FASTPATH
automatically selects a standby from the existing stack units.
Syntax
no standby
Default Configuration
This command has no default configuration.
Command Mode
Stack Global Configuration