Dell PowerEdge M600 - Manual (Page 652)

656 Loopback Interface Commands
www
.dell.com | support.dell.com
Syntax
show interfaces loopback [loopback-id]
• loopback-id—Loopback identifier. (Range: 0-7)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Examples
The following examples display information about configured loopback interfaces.
console# show interfaces loopback
Loopback Id Interface IP Address Received Packets Sent Packets
------------ ---------- ---------- ---------------- -------------
1 loopback 1 0.0.0.0 0 0
console# show interfaces loopback 1
Interface Link Status.......................... Up
IP Address..................................... 0.0.0.0 0.0.0.0
MTU size....................................... 1500 bytes