Dell PowerEdge M600 - Manual (Page 403)

Radius Commands 393
Radius Commands
auth-port
Use the auth-port command in Radius mode to set the port number for authentication requests of
the designated Radius server.
Syntax
auth-port auth-port-number
• auth-port-number—Port number for authentication requests.
Default Configuration
The default value of the port number is 1812.
Command Mode
Radius mode
User Guidelines
The host is not used for authentication if set to 0.
User must enter the mode corresponding to a specific Radius server before executing this
command.
Example
The following example sets the port number 2412 for authentication requests.
console(config)#radius-server host 192.143.120.123
console(config-radius)#auth-port 2412
deadtime
Use the deadtime command in Radius mode to improve Radius response times when a server is
unavailable by causing the unavailable server to be skipped.