Dell PowerEdge M600 - Manual (Page 193)

Ethernet Configuration Commands 161
Ch Description
---- -----------
1 Output
show interfaces status
Use the show interfaces status command in User EXEC mode to display the status for all
configured interfaces.
Syntax
show interfaces status [ethernet interface | port-channel port-channel-number ]
• interface—A valid Ethernet port.
• port-channel-number—A valid port-channel trunk index.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the status for all configured interfaces.
console>show interfaces status
Port Type Duplex Speed Neg MDIX Link
Mode State
---- ---------- ------ ----- ---- ---- -----
1/g1 1G-Combo-c Full 100 Auto on Up
2/g1 100-Copper Full 100 Off off Down*
2/g2 1G-Fiber Full 1000 Off on Up
Ch Type Duplex Speed Neg Link