Dell PowerEdge M600 - Manual (Page 531)

VLAN Commands 527
console(config-if-1/g8)#switchport general acceptable-frame-type
tagged-only
switchport general allowed vlan
Use the switchport general allowed vlan command in Interface Configuration mode to add VLANs
to or remove VLANs from a general port.
Syntax
switchport general allowed vlan add vlan-list [tagged|untagged]
switchport general allowed vlan remove vlan-list
• add vlan-list—List of VLAN IDs to add. Separate nonconsecutive VLAN IDs with a
comma and no spaces. Use a hyphen to designate a range of IDs.
• remove vlan-list—List of VLAN IDs to remove. Separate nonconsecutive VLAN IDs with
a comma and no spaces. Use a hyphen to designate a range of IDs.
• tagged—Sets the port to transmit tagged packets for the VLANs. If the port is added to a
VLAN without specifying tagged or untagged, the default is untagged.
• untagged—Sets the port to transmit untagged packets for the VLANs.
Default Configuration
Untagged.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
You can use this command to change the egress rule (for example, from tagged to untagged)
without first removing the VLAN from the list.
Example
The following example shows how to add VLANs 1, 2, 5, and 8 to the allowed list.
console(config-if-1/g8)#switchport general allowed vlan add
1,2,5,8 tagged
switchport general ingress-filtering disable
Use the switchport general ingress-filtering disable command in Interface Configuration mode to
disable port ingress filtering. To enable ingress filtering on a port, use the no form of this command.