Dell PowerEdge M600 - Manual (Page 585)

DVMRP Commands 587
DVMRP Commands
ip dvmrp
Use the ip dvmrp command to set the administrative mode of DVMRP in the router to active.
IGMP must be enabled before DVMRP can be enabled.
Syntax
ip dvmrp
no ip dvmrp
Default Configuration
Disabled is the default configuration.
Command Mode
Global Configuration
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets VLAN 15’s administrative mode of DVMRP to active.
console(config)#interface vlan 15
console(config-if-vlan15)#ip dvmrp
ip dvmrp metric
Use the ip dvmrp metric command in Interface Configuration mode to configure the metric for an
interface. This value is used in the DVMRP messages as the cost to reach this network.