Dell PowerEdge M600 - Manual (Page 708)

714 OSPF Commands
www
.dell.com | support.dell.com
show ip ospf virtual-link
Use the show ip ospf virtual-link command in Privileged EXEC mode to display the OSPF Virtual
Interface information for a specific area and neighbor.
Syntax
show ip ospf virtual-link area-id neighbor-id
• area-id—Identifies the OSPF area whose ranges are being displayed. (Range: IP address
or decimal from 0-4294967295)
• neighbor-id—Identifies the neighbor’s router ID. (Range: Valid IP address)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF Virtual Interface information for area 10 and its
neighbor.
console#show ip ospf virtual-link 10 192.168.2.2
Area ID........................................ 10
Neighbor Router ID............................. 192.168.2.2
Hello Interval................................. 10
Dead Interval.................................. 655555
Iftransit Delay Interval....................... 1
Retransmit Interval............................ 5
State.......................................... down
Metric......................................... 0
Neighbor State................................. down
Authentication Type............................ MD5
Authentication Key............................. "test123"
Authentication Key ID.......................... 100