Dell PowerEdge M600 - Manual (Page 694)

700 OSPF Commands
www
.dell.com | support.dell.com
Example
The following example configures OSPF protocol to allow redistribution of routes from the
specified source protocol/routers.
console(config-router)#redistribute rip metric 90 metric-type 1
tag 555 subnets
router-id
Use the router-id command in Router OSPF Configuration mode to set a 4-digit dotted-decimal
number uniquely identifying the router OSPF ID.
Syntax
router-id ip-address
• ip-address—IP address that uniquely identifies the router OSPF ID.
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example defines the router OSPF ID as 5.5.5.5 .
console(config)#router ospf
console(config-router)#router-id 5.5.5.5
router ospf
Use the router ospf command in Global Configuration mode to enter Router OSPF mode.
Syntax
router ospf
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode