Dell PowerEdge M600 - Manual (Page 128)

94 User Interface Commands
www
.dell.com | support.dell.com
end
Use the end command to get the CLI user control back to the privileged execution mode or user
execution mode.
Syntax Description
end
Default Configuration
This command has no default configuration.
Command Mode
All command modes
User Guidelines
No specific guidelines.
Example
console(config)#end
console#end
console>
exit (configuration)
Use the exit command to go to the next lower command prompt.
Syntax
exit
Default Configuration
This command has no default configuration.
Command Mode
All command modes
User Guidelines
There are no user guidelines for this command.
Example
The following example changes the configuration mode from Interface Configuration mode
to User EXEC mode.