Dell PowerEdge M600 - Manual (Page 628)

632 IPv6 Routing Commands
www
.dell.com | support.dell.com
Example
The following example enables IPv6 routing, which has not been configured with an explicit
IPv6 address.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 enable
ipv6 forwarding
Use the ipv6 forwarding command in Global Configuration mode to enable IPv6 forwarding on a
router.
Syntax
ipv6 forwarding
no ipv6 forwarding
Default Configuration
Enabled is the default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example globally enables IPv6 forwarding.
console#configure
console(config)#ipv6 forwarding
console(config)#no ipv6 forwarding
ipv6 mtu
Use the ipv6 mtu command in Interface Configuration mode to set the maximum transmission
unit (MTU) size, in bytes, of IPv6 packets on an interface. This command replaces the default or
link MTU with a new MTU value.