Dell PowerEdge M600 - Manual (Page 736)

742 OSPFv3 Commands
www
.dell.com | support.dell.com
Syntax
redistribute {static | connected} [metric metric] [metric-type {1 | 2}] [tag tag ]
no redistribute {static | connected} [metric] [metric-type] [tag]
• metric—Metric value used for default routes. (Range: 0-16777214)
• tag—Tag. (Range: 0-4294967295)
Default Configuration
2 is the default value for metric-type, 0 for tag.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the OSPFv3 protocol to allow redistribution of routes from
the specified source protocol/routers.
console(config)#ipv6 router ospf
console(config-rtr)#redistribute connected
router-id
Use the router-id command in Router OSPFv3 Configuration mode to set a 4-digit dotted-decimal
number uniquely identifying the Router OSPF ID.
Syntax
router-id router-id
• router-id—Router OSPF identifier. (Range: 0-4294967295)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.