Dell PowerEdge M600 - Manual (Page 336)

320 802.1x Commands
www
.dell.com | support.dell.com
Example
The following example sets the number of seconds that the switch remains in the quiet state
following a failed authentication exchange to 3600.
console(config)# interface ethernet 1/g16
console(config-if-1/g16)# dot1x timeout quiet-period 3600
dot1x timeout re-authperiod
Use the dot1x timeout re-authperiod command in Interface Configuration mode to set the
number of seconds between re-authentication attempts. To return to the default setting, use the
no form of this command.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
• seconds — Number of seconds between re-authentication attempts. (Range: 300 -
4294967295)
Default Configuration
Re-authentication period is 3600 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the number of seconds between re-authentication attempts to
300.
console(config)# interface ethernet 1/g16
console(config-if-1/g16)# dot1x timeout re-authperiod 300
dot1x timeout server-timeout
Use the dot1x timeout server-timeout command in Interface Configuration mode to set the time
that the switch waits for a response from the authentication server. To return to the default setting,
use the no form of this command.