Dell PowerEdge M600 - Manual (Page 715)

OSPFv3 Commands 721
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the default metric value for the default route advertised
into the NSSA.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 nssa default-info-originate
area nssa no-redistribute
Use the area nssa no-redistribute command in Router OSPFv3 Configuration mode to configure
the NSSA ABR so that learned external routes will not be redistributed to the NSSA. Use the no
form of the command to remove the configuration.
Syntax
area areaid nssa no-redistribute
no area areaid nssa no-redistribute
• areaid—Valid OSPF area identifier.
Default Configuration
This command has no default configuration.
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the area 1 NSSA ABR so that learned external routes will
not be redistributed to the NSSA.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 nssa no-redistribute