Dell PowerEdge M600 - Manual (Page 230)

202 LACP Commands
www
.dell.com | support.dell.com
Syntax
lacp system-priority value
no lacp system-priority
• value—Value of the priority. (Range: 1 - 65535)
Default Configuration
The default system priority value is 1.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the system priority to 120.
console(config)#lacp system-priority 120
lacp timeout
Use the lacp timeout command in Interface Configuration mode to assign an administrative
LACP timeout. To reset the default administrative LACP timeout, use the no form of this
command.
Syntax
lacp timeout {long|short}
no lacp timeout
• long—Specifies a long timeout value.
• short—Specifies a short timeout value.
Default Configuration
The default port timeout value is long.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.