Dell PowerEdge M600 - Manual (Page 795)

Tunnel Interface Commands 805
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Tunnel) mode
User Guidelines
This command has no user guidelines.
Example
The following example specifies the destination transport address of tunnel 1.
console(config)#interface tunnel 1
console(config-if-tunnel1)#tunnel destination 10.1.1.1
tunnel mode ipv6ip
Use the tunnel mode ipv6ip command in Interface Configuration mode to specify the mode of the
tunnel.
Syntax
tunnel mode ipv6ip
no tunnel mode ipv6ip
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Tunnel) mode
User Guidelines
This command has no user guidelines.
Example
The following example specifies ipv6ip mode for tunnel 1.
console(config)#interface tunnel 1
console(config-if-tunnel1)#tunnel mode ipv6ip