Dell PowerEdge M600 - Manual (Page 409)

Radius Commands 399
Example
The following example configures the source IP address used for communication with Radius
servers to 10.1.1.1.
console(config)#radius-server source-ip 10.1.1.1
radius-server timeout
Use the radius-server timeout command in Global Configuration mode to set the interval for
which a switch waits for a server host to reply. To restore the default, use the no form of this
command.
Syntax
radius-server timeout timeout
no radius-server timeout
• timeout—Specifies the timeout value in seconds. (Range: 1 - 30)
Default Configuration
The default value is 3 seconds.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the interval for which a switch waits for a server host to reply to
5 seconds.
console(config)#radius-server timeout 5
retransmit
Use the retransmit command in Radius mode to specify the number of times the Radius client
retransmits requests to the Radius server.
Syntax
retransmit retries
• retries—Specifies the retransmit value. (Range: 1-10 attempts)