Dell PowerEdge M600 - Manual (Page 705)

OSPF Commands 711
Syntax
show ip ospf neighbor [interface vlan vlan-id] [ip-address]
• vlan-id—Valid VLAN ID.
• ip-address—Valid IP address of the neighbor.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following examples display information about OSPF neighbors on the specified Ethernet
and IP interfaces.
console#show ipv6 ospf neighbor interface tunnel 1
Router ID Priority Intf Interface State Dead
ID Time
------------- -------- ----- ----------- ---------------- ----
4.1.0.0 0 13 tunnel 1 Full/DR-OTHER 30
show ip ospf range
Use the show ip ospf range command in Privileged EXEC mode to display information about the
area ranges for the specified area-id.
Syntax
show ip ospf range area-id