Dell PowerEdge M600 - Manual (Page 682)

688 OSPF Commands
www
.dell.com | support.dell.com
Example
The following example sets a value of 50 for the default metric.
console(config-router)#default-metric 50
distance ospf
Use the distance ospf command in Router OSPF Configuration mode to set the route preference
value of OSPF in the router. The range for the spectrum intra/inter/type1/type2 is 2-255, but values
must be assigned so that intrathe specified metric to its default value.
Syntax
distance ospf {intra |inter \ type1 | type2} integer
no distance ospf {intra |inter \ type1 | type2}
• integer—The preference of the route. Lower route preference values are preferred when
determining the best route. (Range: 2-255)
Default Configuration
intra: 8, inter: 10, type1: 13, type2: 150
Command Mode
Router OSPF Configuration mode
User Guidelines
The OSPF specification (RFC 2328) requires that preferences must be given to the routes
learned via OSPF in the following order: intra < inter < type-1 < type-2.
Examples
The following examples set route preference values of OSPF in the router.
console(config-router)#distance ospf intra 4
console(config-router)#distance ospf type1 19
distribute-list out
Use the distribute-list out command in Router OSPF Configuration mode to specify the access list
to filter routes received from the source protocol. Use the no form of the command to remove the
specified source protocol from the access list.
Syntax
distribute-list accesslistname out {rip|static \ connected}