Dell PowerEdge M600 - Manual (Page 444)

436 SNMP Commands
www
.dell.com | support.dell.com
Default Configuration
The default configuration is 3 retries, and 15 seconds timeout.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example enables SNMP traps for host 192.16.12.143.
console(config)# snmp-server host 192.16.12.143 Dell_powerconnect
traps v2
snmp-server location
Use the snmp-server location command in Global Configuration mode to set the system location
string. To remove the location string, use the no form of this command.
Syntax
snmp-server location text
no snmp-server location
• text—Character string describing the system location. (Range: 1 to 160 characters.)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the device location as "New_York".
console(config)# snmp-server location New_York