Dell PowerEdge M600 - Manual (Page 771)

PIM-SM Commands 779
show ip pimsm neighbor
Use the show ip pimsm neighbor command in Privileged EXEC mode to display neighbor
information for PIM-SM on the specified interface.
Syntax
show ip pimsm neighbor [vlan vlan-id|all]
• vlan-id—Valid VLAN ID
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays neighbor information for PIM-SM on all interfaces.
console#show ip pimsm neighbor all
NEIGHBOR TABLE
Interface IP Address Up Time Expiry Time
(hh:mm:ss) (hh:mm:ss)
--------- ---------------- ---------- ------------
show ip pimsm rp
Use the show ip pimsm rp command in Privileged EXEC mode to display PIM information for
candidate Rendezvous Points (RPs) for all IP multicast groups or for the specific group address or
group mask provided in the command. The information in the table is displayed for each IP
multicast group.
Syntax
show ip pimsm rp {groupaddr groupmask |candidate|all}
• groupaddr — Valid IP address.
• groupmask — Valid subnet mask.
• all — Enter "all" for all group addresses.