Dell PowerEdge M600 - Manual (Page 681)

OSPF Commands 687
• always—Always advertise default routes.
• integer—The metric (or preference) value of the default route. (Range: 1-16777214)
• 1—External type-1 route.
• 2—External type-2 route.
Default Configuration
The default metric is none and the default type is 2.
Command Mode
Router OSPF Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example always advertises default routes.
console(config-router)#default-information originate always metric
100 metric-type 1
default-metric
Use the default-metric command in Router OSPF Configuration mode to set a default for the
metric of distributed routes. Use the no form of the command to remove the metric from the
distributed routes.
Syntax
default-metric integer
no default-metric
• integer—The metric (or preference) value of the default route. (Range: 1-16777214)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode
User Guidelines
This command has no user guidelines.