Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector - Manual (Page 308)

308 Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012
Appendix B Frequently Asked Questions and Answers
• The Enpac 2500 is correctly connected to the computer.
• You choose Tools > Load/Unload in Emonitor.
The communication link remains until you do one of the following to break
communication.
• Close the Load/Unload dialog in Emonitor.
• Disconnect the cable between the computer and Enpac 2500.
• Press the READ/OK key on the Enpac 2500.
Collecting Data with the
Enpac 2500 Why does the Enpac 2500 seem to skip measurements at a location?
Emonitor and the Enpac 2500 are designed to make collecting data as quick and
efficient as possible. To shorten data collection time, Emonitor combines two or
more measurement definitions at a location into a single measurement. This
allows you to collect two or more measurements by pressing a single key on the
Enpac 2500.
See Collecting and Reviewing Data on page 119 .
Why wont the Enpac 2500 combine magnitude and phase or manual
entry measurements at a location?
Two exceptions exist for combining measurement definitions. Emonitor and the
Enpac 2500 cannot combine magnitude + phase measurements with any other
measurements. Nor can they combine manual entry measurements with any
other measurements. Both types remain as individual measurements when loaded
into the Enpac 2500.
TIP Emonitor indicates when it completes the loading or unloading process.