Moving around in a balance run, Reviewing data, Moving around in a balance run reviewing data – Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector User Manual
Page 233: For de
Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012
233
Balancing Application
Chapter 8
Moving Around in a Balance
Run
You can return to a previous step in the balance run by pressing the 0 (Shift) key
and F1 (Go To) simultaneously. The Go to screen appears and lists all the steps in
the balance run. The steps that are completed have a check mark next to them.
Highlight the step that you want to return to, then press F2 (Go to pt). The
Enpac 2500 displays the selected screen. You can then retake a measurement, if
necessary.
Reviewing Data
This section describes the Vibration Summary Table and the Weights Summary
Table screens. These screens can be used to review the data in the balance run.
Additionally, the Combine Weights screen is described. This screen allows you to
combine the correction weights into one weight.
The check mark indicates that
the step has been completed.
You can go back to any step that
has a check mark next to it.
IMPORTANT
You can only return to steps that have check marks next to them.