Collect a process dc voltage measurement – Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector User Manual
Page 128
128
Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012
Chapter 4
Collecting and Reviewing Data
Collect a Process DC Voltage Measurement
Once you have created a route in the Emonitor Software and uploaded it to the
data collector you can begin to take the measurement.
See the Emonitor User Manual, publication
for
information about creating routes and loading them into the data
collector.
Follow these steps to collect a Process DC voltage measurement.
1.
Attach the DC voltage input to the data collector and correct location.
2.
From the Data Collection screen, press Enter.
3.
Select the process route you uploaded from the Emonitor software and
press Enter to start your measurement for the current point.
The DC Volts Measurement screen appears.
The instrument continually updates the magnitude value for the
measurement.
TIP
For DC process measurements, conservative autoranging is always used to
minimize the effects of internal DC offsets.
For more information about Autoranging, see