Recalling a setup – Rockwell Automation 1441-PEN25-Z Enpac 2500 Data Collector User Manual
Page 281
Rockwell Automation Publication GMSI10-UM002D-EN-E - August 2012
281
Run Up/Coast Down Application
Chapter 10
Recalling a Setup
You can recall a previously saved setup and use it to collect another measurement.
The setup may have been saved only as a setup, or may have been saved with the
recorded data.
Refer to Saving Run Up/Coast Down Measurements on page 279
1.
Select RUCD on the Main Menu and press the READ/OK key.
The RUCD screen appears.
2.
Select Recall and press the READ/OK key.
The RUCD - Load Setup screen appears.
3.
Highlight the filename that you want recall and press F4 (Open).
The RUCD - Setup screen appears.
4.
You can edit the settings or start collecting data.
For information on editing the settings, see
.
For information on collecting RUCD measurements, see