HP StoreEver TapeAssure Software - Manual (Page 91)

Example hp_ltt -f listtest p=2.3.0[2-4/0/4/1/0.3.0]
Results in the following:
Running tests (CLF)
Description L&TT can be launched from the command line to perform various tests. L&TT
runs the test specified by the testname parameter on the device specified by
the device path (p) parameter. These two parameters are required; all other
parameters are optional.
The following tests are currently supported from the command line:
•
Connectivity test
•
Device Analysis test
•
Device Self-Test
•
Assessment test for SDLT, LTO, and DDS tape drives
•
LTO Media Assessment test
•
“DDS Media Assessment Test” (page 110)
Syntax hp_ltt -f test p= testname=
[password=] [iohistory=]
[testopt=] [testopt=
name:option2 value>][instname=]
[dirpath=]
Parameters Enter the device path. The format for the device path varies
depending on the operating system. To determine the proper p
format for your device, first perform a scan of the bus (see
Scanning the bus (page 89) ). Output of the scan is written to
Command line functions 91