Mo media validation test, Move test, Mo media validation test move test – HP StoreEver TapeAssure Software User Manual
Page 127

Available for
AIT, DDS, DLT, SDLT, VS80/160 or DLT1, LTO, and STK 9840 tape
drives, MO and UDO optical drives.
MO Media Validation test
Description
This test validates magneto-optical (MO) or ultra-density optical (UDO)
media and reports any errors or blank spaces present in the media, if
any. This is a non-destructive test and is available for all MO and UDO
devices.
NOTE:
For instructions on how to perform this test, see
or
Running the tests (CSI) (page 73)
.
When to run
Run this test when you suspect a problem with your MO or UDO media.
Average duration
< 5 minutes using default test options, but dependent on the amount of
data on the media. Can take longer if media is full.
Other notes
Test requires that a minimum amount of data is already written on the
media, otherwise the test will fail. The amount of data varies depending
on drive technologies and options.
Available for
MO and UDO optical drives
Move test
Description
This test performs a move command in a library or autoloader using
source and destination elements specified in the test options. When the
move command is finished, a second move command returns the
cartridge to its original location. This sequence can be repeated using
an optional loop count.
NOTE:
For instructions on how to perform this test, see
or
Running the tests (CSI) (page 73)
.
Diagnostic tests
127