HP StoreEver TapeAssure Software - Manual (Page 11)

◦ Red Hat Enterprise Linux 6.4 support added.
◦ SuSE 11 SP3 support added.
•
Generic to tool
Ethernet access is now available for LTO-6 drives. ◦
◦ The Ethernet IP address can now be entered manually for library drives.
◦ Included more “Factory” level content in the “Everything” level.
What's new in L&TT 4.15
L&TT 4.15 is an incremental release, which incorporated enhancements and fixes from L&TT 4.14
SR1 and L&TT 4.14 SR2, and targets:
•
LTO-6 support.
•
A new LTO Data Assessment test, which checks the quality of the data on the tape.
•
Continued usability improvements.
Enhancements and fixes in L&TT 4.15
•
Tape libraries and autoloaders
LTO-6 support is added for ESL G3, EML, MSL, and 1/8 G2 ◦
◦ Selection time of ESL-e library drives over Ethernet has been significantly reduced. (L&TT
4.14 SR1)
•
Tape drives
Added support for LTO-6 tape drives. ◦
◦ Firmware can now be downgraded without using a password. HP recommends that
firmware not be downgraded, but this capability is available to verify that an issue is not
related to a firmware upgrade.
◦ The local timezone is now correctly reflected in the ticket if the time can be decoded. This
feature is applicable for LTO-5 and later generation tape drives with the hp_lto.sys
driver on Windows.
◦ The CM tape directory is now decoded in the classic section of the ticket.
◦ Log page 0x16 is now decoded in the classic section of the ticket. This page shows host
reported errors and is an alternative to using the current fault log.
◦ Additional decoding is now provided for multiple partition tapes.
◦ Corrected an issue with the NFF test where the DAX data for write margin was incorrect.
This issue did not affect the pass/fail criteria for the test, only the DAX data. (L&TT 4.14
SR2)
◦ Updated test reporting to be consistent between the NFF test and LTO Drive Assessment
Test. (L&TT 4.14 SR2)
◦ Added channel variation reporting to the LTO support ticket, under Drive Health. (L&TT
4.14 SR2)
◦ Updated LTO support ticket output so that all items useful to non-factory personnel are
available without a password. (L&TT 4.14 SR2)
What's new 11