Running l&tt commands from removable media, Command line functions – HP StoreEver TapeAssure Software User Manual
Page 88

Running L&TT commands from removable media
You can run L&TT commands from removable media, such as a USB flash drive or CD. See
L&TT from computers without L&TT installed (page 178)
for instructions to install L&TT on the removable
media. Use the dirpath option in the commands to specify a directory for the L&TT runtime files.
Command line functions
This section lists the basic functions that can be performed using the CLF. The following conventions
apply to all functions:
•
All parameter values that contain white spaces must be entered in double-quotes. For example,
if the file firmware.frm exists in the C:\LTT Firmware Files directory, then the file
parameter must be specified as follows:
file=”C:\LTT Firmware Files\firmware.frm”
•
If a test option name contains white spaces, then the whole option name/value pair must be
entered in double quotes as follows:
testopt=”Looping Value:3”
The test options, test progress, and test results are displayed in the terminal window.
Figure 42 Example CLF output
NOTE:
When executing command line functions in Open VMS, replace the hp_ltt string with
@start_ltt
. The rest of the command syntax is the same.
The following functions are available through the command line:
Configuring L&TT
Scanning the bus
Listing supported tests (CLF)
88
Command line functionality