HP StoreEver TapeAssure Software - Manual (Page 67)

Some commands require an argument. For example, the select command requires a number
that corresponds to the device you want to select in the device list. To select the first device in the
list, the syntax is:
select 1
If you enter a command with an invalid or missing argument, an error message is displayed.
Using the Scan Mode Selection screen
When the CSI version of L&TT is started, the Scan Mode Selection screen opens.
Figure 28 Scan Mode Selection screen
When L&TT starts, it performs a device scan to identify all the devices connected to the computer,
either directly or through a SAN. In large SAN environments, this scan can take a long time.
The first time L&TT is run, it must perform a full hardware scan (Hardware Scan option). After
that is done, the results of the scan are automatically saved so that the next time L&TT is started,
the Saved/Manual Scan option can be used. If the Saved/Manual Scan option is selected
before a hardware scan is done, the list of available devices will be empty.
If you select Saved/Manual Scan, the Saved/Manual Scan screen opens.
Using the command screen interface (CSI) 67