Library quick check test – HP StoreEver TapeAssure Software User Manual
Page 116

•
Barcode Mode
— Specify how bar codes are handled. Choose one of the following options:
Show all
— Shows all bar codes
◦
◦
Show suspect
— Shows only suspect bar codes (default)
◦
Off
— Does not show bar codes
•
Slot-to-Slot Moves
— Select one of the following options for the slot-to-slot test:
All
— Moves all cartridges
◦
◦
Random
— Moves randomly selected cartridges (default)
◦
Off
— No cartridges are moved
•
Random Coverage
— When Slot-to-Slot Moves is set to Random, specify the percentage of
units covered during random test. The default is 20%.
•
Drive Load Mode
— Specify whether or not to perform the Drive Load test. The default
setting is on.
•
Drive Test Option
— If the Drive Load test is enabled, specify one of the following options:
Off
◦
◦
Data loop back (default)
◦
Read-only
◦
Read/write
•
Cartridge Load Test
— Specify one of the following options for the Cartridge Load test:
Off (default)
◦
◦
Single drive
◦
Multiple drives
◦
All drives
•
CM Integrity Mode
—Specify whether to enable the CM integrity check option for LTO
drives. The default setting is on.
Library Quick Check test
Description
The Library Quick Check test performs a quick check of both the library
and installed tape drives for both VLS/D2D and real libraries. The test
checks the library move functionality and checks the read, write, and
load functions of each tape drive installed in the library.
The test starts by moving any tapes currently loaded in the tape drives
back to their source slots. If source information is not available for any
tapes loaded in drives, the test will exit with a warning and test status
Incomplete
. After moving any currently loaded tapes back to their
source slots, there must be at least one empty slot or the test will skip
the slot-to-slot move portion of the test.
The test identifies test tapes and the empty test slot based on the types
of tape drives installed in the library and the value of the Starting slot
option. For example, if the library has a mixture of LTO2 and LTO4 tape
drives and the value of the Starting slot option is 10, the test will identify
the first LTO2 tape and the first LTO4 tape starting with slot 10, and
116
Tests and utility functions